Terminal Sterilization

EO Sterilization for Flexible Endoscopes

One million times more lethal than high-level disinfection. The only sterilization system cleared by FDA 510(k) for terminal sterilization of duodenoscopes and colonoscopes — processed in the Andersen EOGas4.

Watch: 2-Minute Overview

See How the Service Works

The case for ethylene oxide, and exactly what happens to your scope.

Read the video transcript

Does your facility treat immune-compromised patients? Or younger patients whose immune systems are still developing? If so, how your endoscopes are reprocessed matters more than you might think. Over the next few minutes we will introduce Parametrik's ethylene oxide sterilization service for rigid and flexible endoscopic instruments: what it is, why it raises the standard of safety for your highest-risk patients, and how little it asks of your staff.

So what is the higher standard? Ethylene oxide gas. Manufacturer instructions for use typically list ethylene oxide sterilization as an available and superior method for these devices. It is used throughout the medical device industry to assure the sterility of new devices, and it is the primary method at industrial scale. It is rarely available inside a hospital, and that is unfortunate, because the endpoints are not the same. As the chart shows, ethylene oxide achieves a ten-to-the-minus-twelve reduction in organisms and inactivates spores, roughly a million times the margin of disinfection. When a device will be used on a pediatric or immune-compromised patient, that difference deserves the attention of your infection prevention team.

Here is exactly what happens to your scope. Every endoscope is inspected on arrival and cleaned to the manufacturer's instructions for use. It is inspected again after cleaning, then terminally sterilized with ethylene oxide and returned to you in transport-safe sterile packaging. Complete documentation travels with it, and the sterile package carries a six-month shelf life, so you can hold ready-to-use scopes on your shelf. There is no capital to buy and no new process for your staff to learn.

To bring it together. Immune-compromised patients need a higher standard of processing for their endoscopes, and ethylene oxide sterilization gives you and your patients that added safety. Three things to remember. Processing takes twenty-four hours. A sterile scope stores for six months, ready when you need it. And the process is approved by the manufacturers who make your scopes.

Parametrik. We are redefining clean in the O.R. If you would like to talk about protecting your highest-risk patients, call us at (833) 763-8745, or email info@parametrik.net. You can also visit parametrik.net to arrange a pick-up or a shipping kit. Thank you for your time.

1,000,000×

More lethal than HLD

24 hour

Turnaround time

6 month

Sterile shelf life

Why a Higher Standard?

Endoscopes have been linked to hospital-acquired infections, and they are hard to clean. A study in the American Journal of Infection Control found that 71% of reusable scopes deemed ready for patient use at three major U.S. hospitals tested positive for bacteria.

Since 2017, FDA has required manufacturers of certain reusable devices to submit validated reprocessing instructions with their 510(k) filings. Yet gastroenterologists still depend on complex reusable scopes for specialty procedures and difficult patient profiles, so the reprocessing question does not go away. Manufacturer instructions for use typically list ethylene oxide sterilization as an available, superior method.

High-Level Disinfection

6-log reduction

of the most resistant mycobacteria (1,000,000×).

EO Terminal Sterilization

12-log reduction

of the most resistant bacterial spores, with a sterility assurance level of 10-6.

Source: ANSI/AAMI ST91:2021, Annex I, microbicidal methods for flexible endoscope processing.

Why Andersen EOGas4?

Parametrik utilizes the Andersen Products EOGas4 — a 21st century Ethylene Oxide technology purpose-built for endoscope sterilization. The green technology is environmentally friendly and produces near-zero emissions, compliant with the strictest governmental emission standards including New York and California.

FDA 510(k) Cleared

The only sterilization system cleared for terminal sterilization of duodenoscopes and colonoscopes.

Green Technology

Near-zero emissions. Compliant with the strictest US emissions standards.

Validated Cycles

Each load includes biological indicators and full cycle records for chain-of-custody.

OEM Approved

Aligned with major endoscope OEM reprocessing IFUs.

Two Service Levels

Pick the depth of service that fits your operation.

Level I

EO Sterilization Only

Send us a scope already cleaned to the manufacturer’s IFU. We perform terminal Ethylene Oxide sterilization in the Andersen EOGas4 and return it sterile-packaged within 24 hours.

Level II

Full Reprocessing + EO

Cleaning per the manufacturer’s IFU, forced-air drying, VerifyAi automated borescope inspection of the lumens, and terminal EO sterilization. The complete service.